Reply fonts

  • 2 Replies
  • 1452 Views
*

Offline Mad-Batter

  • Myotis
  • ***
  • 50
Reply fonts
« on: June 01, 2014, 10:41:26 PM »
I know this will be quite an obscure question.  :)

I am using v 1.61 still. :)

I can customize almost all of the fonts in the program using Options/Pref/Viewer

HOWEVER.... I can't find where I can change the font for a regular reply message.

I would like MS Sans Serif, the same as I have set up for the rest.

On my ASUS Transformer T-100, the default reply font is a very fuzzy courier-ish one.

Thanks for your help!






*

Offline Anne

  • Administrator
  • Golden Crowned
  • *****
  • 1193
  • Gender: Female
  • Rabbit Lady
    • Yobunny Enterprises
  • The Bat! version: 6.8.8
Re: Reply fonts
« Reply #1 on: June 16, 2014, 01:22:12 AM »
OK I think for this you need to change the setting as follows...

Options > Editor Preferences > Display tab >
click on the Change button at the top right by where it says Font to select the font you want to use. You can also amend the size and choose bold. italic etc... there too.

Hope this helps.  8)
Cheers!
Anne


*

Offline Mad-Batter

  • Myotis
  • ***
  • 50
Re: Reply fonts
« Reply #2 on: June 18, 2014, 02:38:17 AM »
OK I think for this you need to change the setting as follows...

Options > Editor Preferences > Display tab >
click on the Change button at the top right by where it says Font to select the font you want to use. You can also amend the size and choose bold. italic etc... there too.

Hope this helps.  8)

Thanks very much Anne. I never would have looked there.  :)
I was able to change it on my PC but won't be able to test it out on my Mom's tablet for a week or so.

It's too bad there are so few fonts to choose from in this list, compared to the font selection for reading messages etc.
No 'MS Sans Serif' as in the other lists.


 

SMF spam blocked by CleanTalk